Heat Pump Cost in Diamondhead, Mississippi

In Diamondhead, a typical heat pump installation costs $3,561–$6,727 before rebates, based on local HVAC labor rates ($23/hr) and current equipment pricing.

Avg Cost: $3,561–$6,727
13.8¢/kWh
0 Rebates Available
Climate Zone 2
Coast Electric Power Assn - (MS)

Get Your Diamondhead Heat Pump Estimate

1
2
3
4

Where is your home?

We'll use your ZIP code to find local prices, rebates, and climate data.

Looking up...

Diamondhead Heat Pump Cost by Home Size

These estimates use the BLS median HVAC installer wage for the Diamondhead metro area ($23/hr), multiplied by standard crew-hours and shop overhead. Equipment pricing reflects ENERGY STAR certified heat pump retail data.

Cost by size
2T
$3,420–$6,465
3T
$3,561–$6,727
4T
$3,679–$6,947
5T
$4,254–$8,014
3-ton cost split
Equipment
$1,781–$3,307
Labor
$1,280–$1,920
Materials
$500–$1,500
Electricity rate
Diamondhead
13.8¢
National
16.0¢
Home SizeSystem SizeEquipmentLaborTotal Installed
Under 1,500 sq ft2 ton$1,640–$3,045$1,280–$1,920$3,420–$6,465
1,500–2,500 sq ft3 ton$1,781–$3,307$1,280–$1,920$3,561–$6,727
2,500–3,500 sq ft4 ton$1,899–$3,527$1,280–$1,920$3,679–$6,947
Over 3,500 sq ft5 ton$2,474–$4,594$1,280–$1,920$4,254–$8,014

Labor reflects a 2-person crew for 8–12 hours at local shop rates. Materials and permits ($500–$1,500) are included in the total.

What Affects Heat Pump Cost in Diamondhead?

Local Labor Rates

Labor is the biggest variable between cities. The BLS reports a median HVAC installer wage of $23/hr in the Diamondhead metro area. After shop overhead (insurance, vehicles, permits), contractors typically bill $80/hr. A standard 2-person crew for 8–12 hours puts Diamondhead labor at $1,280–$1,920 for a typical install. That's below the national median of $28/hr, keeping installation costs relatively affordable.

System Size for Diamondhead Homes

In Climate Zone 2, cooling capacity is the primary sizing factor — hot summers drive the load calculation. A Diamondhead home under 1,500 sq ft typically needs a 2-ton system ($3,420–$6,465), while homes over 3,500 sq ft need 5 tons ($4,254–$8,014).

Efficiency & Your Electricity Rate

At Diamondhead's rate of 13.8¢/kWh (per EIA / Coast Electric Power Assn - (MS)), mid-efficiency models (16–18 SEER2) typically offer the best balance of upfront cost and operating savings. The difference between a 15 SEER2 and 20 SEER2 system is roughly $235/year on heating alone for a mid-size home.

Cooling-Dominant Climate

In Climate Zone 2, your heat pump runs in cooling mode most of the year. Prioritize a high SEER2 rating over HSPF2 — the cooling efficiency has a larger impact on your annual electricity bill. Proper dehumidification is also important; two-stage or variable-speed compressors handle humid conditions much better than single-stage units.

Diamondhead Heat Pump Rebates & Incentives

Incentive data sourced from the Rewiring America database. Programs and amounts change frequently — verify eligibility with your contractor or program administrator.

Federal 25C Tax Credit

Expired December 31, 2025. Previously offered up to $2,000 for qualifying heat pumps. Congress may extend or replace this credit — check IRS.gov for updates.

Expired

Diamondhead Electricity Rates & Operating Cost

Diamondhead residents served by Coast Electric Power Assn - (MS) pay approximately 13.8¢ per kWh for residential electricity, according to EIA and NREL/OpenEI data. The national average is approximately 16¢/kWh.

At this moderate rate, a mid-efficiency heat pump (16–18 SEER2) typically offers the best balance between upfront cost and long-term energy savings. A typical 3-ton heat pump in Diamondhead costs roughly $971–$1,295/year to heat a mid-size home (assuming COP 2.5 and 60–80 MMBtu annual heat load).

Diamondhead Climate & Heat Pump Performance

IECC Zone 2
Hot-Humid

What is Climate Zone 2?

The IECC divides the US into 8 climate zones based on heating and cooling degree days. Zone 1 is the hottest (south Florida, Hawaii); Zone 8 is subarctic (interior Alaska). Hancock county falls in Zone 2. Zone 2 has long, hot summers and short, mild winters. Typical winter lows are 25–40°F, with occasional freezes but rarely sustained cold.

How Heat Pumps Perform in Zone 2

Heat pumps spend most of the year cooling. Heating demand is moderate — standard heat pumps maintain full capacity well above local winter lows. Backup heat is rarely triggered.

What We Recommend for Diamondhead

A mid-to-high efficiency system (16–20 SEER2) is ideal. Two-stage or variable-speed compressors improve summer dehumidification, which is especially valuable in humid areas.

Nearby Cities in Mississippi

Frequently Asked Questions

How much does a heat pump cost in Diamondhead?

Based on BLS HVAC labor data for the Diamondhead metro and ENERGY STAR equipment pricing, a typical 3-ton heat pump installation costs $3,561–$6,727. That breaks down to $1,781–$3,307 for equipment, $1,280–$1,920 for a 2-person installation crew, and $500–$1,500 for materials and permits. Smaller homes (2-ton) start around $3,420; larger homes (5-ton) can reach $8,014.

What rebates are available in Diamondhead?

The federal 25C tax credit (up to $2,000) expired December 31, 2025, but Congress may extend or replace it — check IRS.gov for updates. Check with your utility (Coast Electric Power Assn - (MS)) for local incentive programs.

What does electricity cost in Diamondhead?

According to EIA and NREL/OpenEI data, Diamondhead residents served by Coast Electric Power Assn - (MS) pay approximately 13.8¢ per kWh. This is near the national average of 16¢/kWh.

Do heat pumps work well in Diamondhead's climate?

Zone 2 has long, hot summers and short, mild winters. Typical winter lows are 25–40°F, with occasional freezes but rarely sustained cold. Heat pumps spend most of the year cooling. Heating demand is moderate — standard heat pumps maintain full capacity well above local winter lows. Backup heat is rarely triggered. A mid-to-high efficiency system (16–20 SEER2) is ideal. Two-stage or variable-speed compressors improve summer dehumidification, which is especially valuable in humid areas.

Where Our Data Comes From

Estimates reflect typical residential installations. Actual costs vary by contractor, site conditions, and system selection. Last updated March 2026.